Husqvarna ST 124, Руководство оператора

Страница: 15 / 468

Maintenance
Maintenance schedule
Maintenance Daily 20 hours 50 hours 100 hours
Make sure that nuts
and screws are tight-
ened
X
Do a check of the en-
gine oil level
X
Replace oil
1
X X X
Make sure there are
no fuel or oil leaks
X
Remove clogging,
foreign objects in
auger
X
Inspect the tire pres-
sure
2
X
Inspect and change
the spark plug 3
X
Note: It is not necessary to add grease or to do other
maintenance to the gearbox.
To do a general inspection
• Make sure that all nuts and screws on the product
are tightened correctly.
To do a check of the oil level
CAUTION: A too low oil level can do
damage to the engine. Do a check of the oil
level before you start the product.
1. Put the product on level ground.
2. Remove the oil tank cap with the attached dipstick.
3. Clean the oil from the dipstick.
4. Put the dipstick fully into the oil tank to give a correct
picture of the oil level.
5. Remove the dipstick.
6. Examine the oil level on the dipstick.
7. If the oil level is low, fill with engine oil and do a
check of the oil level again.
To replace the engine oil
1. Run the engine a few minutes to make the oil warm.
Warm oil flows better and carries more
contaminants.
WARNING: The engine oil is hot. Avoid
skin contact with the used engine oil.
2. Put the product on level ground.
3. Run the engine until all fuel has been depleted.
4. Remove the ignition key.
5. Put a container under the oil drain plug.
6. Remove the oil drain plug, tip the product backwards
and drain the used oil in the container. (Fig. 50)
7. Put the product back to the operating position.
8. Fit the oil drain plug and tighten it securely by hand.
9. Fill the engine with oil, see
To fill the engine with oil
on page 13 .
1 Replace the oil after the first 20 h, 50 h, 100 h and then every 100 h.
2
See Technical data for correct tire pressure.
3
Check and clean spark plug before use each year.
1272 - 005 - 16.06.2020 15