Husqvarna QR2640X, Руководство пользователя, Страница: 13 / 20

Problem Possible cause Solution
Food products prevent
that water flows into the
water collector. Make sure that food products
do not touch the rear plate.
Water flows on the floor. The melting water outlet is
not connected to the
evaporative tray above the
compressor. Attach the melting water out-
let to the evaporative tray.
Temperature cannot be set. The COOLMATIC function
is switched on. Switch off COOLMATIC man-
ually, or wait until the function
resets automatically to set the
temperature. Refer to "
COOLMATIC function".
DEMO appears on the dis-
play. The appliance is in demon-
stration mode. Keep the Mode pressed for
approximately 10 seconds un-
til a long sound is heard and
display shuts off for a short
time.
Door is misaligned or inter-
feres with ventilation grill. The appliance is not level-
led. Refer to "Levelling".
The temperature in the ap-
pliance is too low/too high. The temperature regulator
is not set correctly. Set a higher/lower tempera-
ture.
The door is not closed cor-
rectly. Refer to "Closing the door".
Food products placed in
the appliance were too
warm. Allow food products to cool to
room temperature before stor-
ing.
Many food products were
put in at the same time. Wait some hours and then
check the temperature again.
The door has been
opened often. Open the door only if necessa-
ry.
The COOLMATIC function
is switched on. Refer to "COOLMATIC func-
tion".
There is no cold air circula-
tion in the appliance. Make sure that there is cold air
circulation in the appliance.
If the advice does not lead
to the desired result, call the
nearest Authorized Service
Centre.
7.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
ENGLISH 13