Husqvarna LT 8005, Руководство оператора

Страница: 10 / 20

Engine maintenance Before use,
each 10 h
After the
first 20 h
Weekly,
each 100 h
Yearly, each
500 h
Drain and clean the fuel tank. O
Drain water from the fuel system. O
Replace the fuel filter. O
Clean the oil filter. O O
Do a check of the fuel injection pump. O
Do a check of the fuel injection nozzle. O
Replace the piston rings. O
To clean the product
CAUTION: Before you clean the product,
attach a plastic bag tightly around the fuel
tank cap. This is to make sure that water
does not go into the venthole in the fuel tank
cap.
• Use running water from a hose or a high-pressure
washer to clean the product.
CAUTION: Do not point the water
directly at the fuel tank cap, electrical
components or the engine.
• Use solvent to clean mechanical parts.
• Remove grease and oil from the handle.
To do a general inspection
• Make sure that all nuts and screws on the product
are tightened correctly.
To tighten the bolts on the rammer
shoe
• Tighten the bolts on the rammer shoe with a wrench.
Note: A 280 mm/11 in. wide rammer shoe has 13
bolts. A 330 mm/13 in. wide rammer shoe has 19
bolts.
To do a check of the engine oil level
1. Put the product in an upright position.
2. Remove the oil tank cap and dipstick.
3. Clean the oil from the dipstick.
4. Put the dipstick back fully into the oil tank.
5. Remove the dipstick.
6. Examine the oil level on the dipstick.
7. If the oil level is low, fill with engine oil and do a
check of the oil level again. Refer to Technical data
on page 13
for the correct type of oil.
To replace the engine oil
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
oil warm and easier to drain.
WARNING: Engine oil is very hot directly
after the engine stops. Let the engine
become cool before you drain the engine oil.
If you spill engine oil on your skin, clean with
soap and water.
1. Put a container below the drain plug for the engine
oil.
10 1167 - 003 - 09.03.2020