Husqvarna K 7000, Руководство оператора

Страница: 19 / 128

To cut in smaller pipes
WARNING:
If the blade is pinched in
the kickback zone, it will cause a severe
kickback.
If the pipe is smaller than the maximum cutting depth of
the product, the cutting operation can be done in 1 step
from top to bottom.
• Cut the pipe from top to bottom.
To cut in larger pipes
WARNING:
If the blade is pinched in
the kickback zone it will cause a severe
kickback.
If the pipe is larger than the maximum cutting depth of
the product, and can not be rolled, the cutting operation
needs to be divided in 5 steps.
• Divide the pipe into 5 sections. Do a mark of those
sections and of a cutting line. Cut a shallow guide
groove around the pipe.
4
1
2
3
5
• Cut those sections in 5 steps with the cutting
directions shown by the arrows in each step.
1
•
2
•
3
•
4
• Make the final separating cut from the top of the pipe
pulling backwards, without involving the upper
quadrant of the blade. Adjust the blade guard to full
forward position for maximum protection.
5
WARNING:
If the pipe is properly
supported, it should not pinch the blade
when separated in section 5. However
be alert if the blade is pinched during the
final separation. If the blade is pinched in
the lower section, the product may pull
forward away from the operator, rather
then resulting in a rotating kickback.
1635 - 003 - 20.08.2021 19