Husqvarna K 7000 Chain, Руководство оператора

Страница: 16 / 104

To cut with an up and down movement
1. Use an up and down movement to cut the work
piece. The product is only held straight at the ends of
the cuts.
2. Use the hand guard as a stop.
To cut holes
WARNING: Make sure that large cut pieces
cannot fall on the operator or the product
when you cut.
CAUTION: Cut pieces can fall and cause
damage to the product if the cuts are made
in the incorrect sequence. Always make the
lower horizontal cut before the top horizontal
cut.
1. Attach a support (A) across the area to be cut (B) to
make sure that the cut piece cannot fall.
A
B
2. Make the lower horizontal cut (C).
C
E
D D
3. Make the 2 vertical cuts (D).
4. Make the top horizontal cut (E).
To stop the product
There are 2 procedures to stop the motor.
• Release the power trigger to stop the motor.
• Push the emergency stop button on the power pack.
Refer to the operator's manual for the power pack.
Lamp indicators in the product
Indication Cause Step
1 green lamp flashes. The product is connected to a power pack and is pre-
pared for operation.
The power output is less than 70% of the maximum
available output in operation.
N/A
16 1455 - 003 - 03.03.2020