Husqvarna FS 600 E, Руководство оператора

Страница: 11 / 452

Operation
Introduction
WARNING:
Read and understand the
safety chapter before you use the product.
To do before you operate the product
CAUTION:
Do not use an extension
cord longer than maximum 25 m and less
than minimum 2.5 mm
2
.
• Read the operator's manual carefully and make sure
that you understand the instructions.
• Read the instructions that are supplied with the
cutting blade by the cutting blade manufacturer.
• Before each operation of the product, do these
steps:
a) Do the daily maintenance. Refer to
Maintenance
schedule on page 22 .
b) Make line marks for all cuts. Prepare the
operation sequence carefully to prevent injury
and damage.
c) Make sure that the cutting blade and the blade
guard is correctly installed. Refer to
To install
a cutting blade on page 12 and To install the
blade guard on page 14
.
d) Adjust the handle to an applicable operation
position. Refer to To adjust the handle height on
page 12
.
e) Fill the water tank or connect the external water
supply. Refer to To fill the water tank on page
17
and
To connect the external water supply on
page 18 .
f) Make sure that the water tube in the blade guard
is open. Each side of the cutting blade must have
sufficient supply of water.
g) Make sure that the pointer is aligned with the
cutting blade. Refer to
To align the pointer with
the cutting blade on page 16
.
h) Connect the power plug of the product into a
extension cord and then into the mains outlet.
i) In some conditions you must reverse phases.
Refer to Error indicator on page 25 .
j) Turn the machine stop button clockwise to make
sure that the button is disengaged.
Cutting blades
WARNING:
Do not use a cutting blade
for other materials than which it is made for.
WARNING:
Only use diamond blades
for wet cutting. The diamond blade must be
applicable to the same speed or a higher
speed than the value given on the product
type plate. Only use diamond blades that
are in compliance with national or regional
standards, for example EN13236 or ANSI
B7.1.
The cutting blade manufacturer gives warnings and
recommendations for the operation and correct
maintenance of the cutting blade. Those warnings are
supplied with the cutting blade.
Diamond blades
WARNING:
Make sure that the
direction of rotation for the diamond blade
shown on the diamond blade aligns with the
direction of rotation shown on the product.
1620 - 004 - 11