Husqvarna F1303V1, Руководство пользователя

Страница: 85 / 140

WHEELS, TIRES 14
83
F02824-12
–
Pull the rear wheel back and mount wheel spindle
3
with the washer and chain adjuster
4
.
Guideline
Mount left and right chain adjusters
4
in the same
position.
–
Mount nut
2
with washer.
–
Make sure that the chain adjusters are positioned cor-
rectly on the screws.
–
Check the chain tension. ( p. 65)
–
Tighten nut
2
.
Guideline
In order for the rear wheel to be correctly aligned, the
markings on the left and right chain adjusters must be
in the same position relative to reference markings
B
.
Nut, rear wheel
spindle
M14x1.5 90 Nm (66.4 lbf ft)
–
Position wheel speed sensor
5
in the hole.
–
Mount and tighten screw
6
.
Guideline
Screw, wheel
speed sensor
M6 7 Nm (5.2 lbf ft)
Loctite
®
243™
Finishing work
–
Remove the rear of the motorcycle from the lifting gear.
( p. 52)
14.5 Checking the rear hub damping rubber pieces
Info
The engine power is transmitted from the rear sprocket to the rear wheel via the six damping rubber
pieces. They eventually wear out during operation. If the damping rubber pieces are not changed in
time, the rear sprocket carrier and the rear hub will be damaged.
Preparatory work
–
Raise the motorcycle with the rear lifting gear. ( p. 52)
–
Remove the rear wheel. ( p. 80)
E01132-10
Main work
(Option: Wire spoked wheels)
–
Check bearing
1
.
» If the bearing is damaged or worn:
–
Change the bearing.
–
Check damping rubber pieces
2
of the rear hub for
damage and wear.
» If the damping rubber pieces of the rear hub are dam-
aged or worn:
–
Change all the damping rubber pieces of the rear
hub.