Husqvarna BMS 150, Руководство оператора, Страница: 15 / 100

To install the wheel weights
1. Install the 5 weights (A) in the wheel (B).
B
C
A
2. Apply LOCTITE
®
243 to the 4 screws (C).
3. Install the 4 screws (C).
4. install the wheel on the product.
D
5. Apply LOCTITE ® 243 to the 5 screws (D).
6. Install the 5 screws (D).
To replace the blade
WARNING:
Use protective gloves. The
blades are very sharp.
WARNING:
Make sure that the product
cannot start when you replace the blade.
1. Use the tool angle control to lift the tool holder from
the floor.
2. Loosen the screws on the tool holder.
3. Remove the blade.
4. Push the new blade into the tool holder.
5. Make sure that the blade is in the correct position.
6. Tighten the screws on the tool holder.
To install a chisel
WARNING:
Use protective gloves. The
blades are very sharp.
WARNING:
Make sure that the product
cannot start when you replace the blade.
1. Remove the blade. Refer to
To replace the blade on
page 15 .
2. Put the chisel (A) on the tool holder (B).
B
A
C
3. Install the washers and screws (C).
To sharpen the blade
WARNING:
Use protective gloves. The
blades are very sharp.
1817 - 002 - 13.04.2022 15