• Only use approved batteries.
• Do not use a defective or damaged battery.
• Only let an approved service center do servicing on
the batteries.
• If the battery leaks, do not let the liquid touch your
body or eyes. If you have touched the liquid, clean
the area with a large quantity of water and soap, and
get medical aid. If you get liquid in your eyes, do not
rub but flush with water for a minimum of 15 minutes
and get medical aid.
• Risk of electrical shock. Do not connect the battery
terminals to keys, coins, screws or other metal. This
can cause a short circuit of the battery.
• Keep the battery away from sunlight, heat or open
flame. The battery can cause burns and/or chemical
burns.
• Keep batteries in storage away from metal objects
such as nails, screws or jewelry.
Safety instructions for maintenance
• Use personal protective equipment. Refer to
Personal protective equipment on page 9
.
• Keep all parts in good condition and make sure that
all fixtures are correctly tightened.
• Do not use a product that is defective. Do the safety
checks, maintenance and the servicing as given in
this manual. All other maintenance work must be
done by an approved service agent.
• Stop the product when you replace the diamond
tools.
• Do the maintenance with the motor stopped and
the power plug disconnected. Always let the motor
become cool before you do maintenance of the
product.
• Do the maintenance of the product on stable level
ground.
• Clean the area around the product from oil and dirt.
Remove unwanted objects.
• Do the maintenance to make sure that the product
on page 20
• Set out clear signs to give a warning to bystanders
that maintenance work is in progress.
• Keep fire extinguishers, medical supplies and an
emergency phone near.
Operation
Introduction
WARNING:
Before you operate the
product, you must read and understand the
safety chapter.
To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Read the operator's manual for the dust extractor
carefully and make sure that you understand the
instructions.
3. Use personal protective equipment. Refer to
Personal protective equipment on page 9
.
4. Make sure that only approved persons are in the
work area.
5. Do daily maintenance. Refer to
.
6. Make sure that the product is assembled correctly
and is not damaged.
7. Put the product on the work area. Make sure that the
surface is level. Make sure that the transportation of
the product to and in the work area is done safely
and correctly. Refer to
.
8. Make sure that there are diamond tools on the
grinding head and that they are tightly attached.
9. For wet grinding, connect the water supply. Refer to
To connect the water supply on page 13
.
10. For BMG 780 RC, put the support wheel in operation
position. Refer to
page 26
.
Diamond tools
There are many different types and configurations of
diamond tools for the product. Metal bonded diamond
tools are used for removal of material and resin bonded
diamond tools are used to polish surfaces. Select the
correct diamond tools for the surface. Speak to your
Husqvarna dealer or go to www.husqvarnacp.com for
support to select the correct tool.
Disc holder alternatives for diamond tools
• Use a Redi lock disc holder to attach metal bonded
diamond tools.
• Use a resin disc holder to attach plastic bonded
diamond tools.
Full set and half set of diamond tools
The configuration of the diamond tool segments has
an effect on the end quality of the surface. The
configuration also has an effect on the operation rate
of the product.
1811 - 001 - 02.05.2022
11
