Note: The recommended setting for the
Virtual guide is 0 min.
4. Select
Save.
3.8.3.2 Lawn Coverage
If the work area includes remote parts that are
connected with narrow passages, the
Lawn
Coverage function is useful to be able to maintain
a well-cut lawn in all parts of the yard. A guide
wire must be installed to use the functions. You
can set a maximum of 3 remote areas.
With the
Lawn Coverage function the product first
follows and then leaves the guide wire after a
certain distance and starts to mow the lawn.
Area A, approximately 50%
Area B, approximately 30%
Area C, approximately 20%
A
C
B
To set the GPS function
1. Select
Installation > Settings > Lawn
coverage in the app.
2. Select
on/off to disable or enable the GPS
function.
Note: When GPS assisted navigation is
enabled it is used while there is a GPS
service. The GPS assisted navigation is
used even if manual settings have been
made. Only when GPS service is not
available, the manual settings are used.
3. Select
Save.
To set the Lawn Coverage function
The
Lawn Coverage function is used to guide the
product to remote parts of the work area. If the
work area includes remote parts that are
connected with narrow passages, the
Lawn
Coverage function is useful to to keep a well-cut
lawn in all parts of the yard. You can set a
maximum of 5 remote areas where the product
starts to cut the lawn.
Each area can be enabled or disabled, without
having to enter the settings again.
1. Select
Settings > Installation > Lawn
coverage in the app.
2. Select
on/off to disable the GPS function to
set the
Lawn Coverage.
3. Select on/off
Area 1-5 to activate the area.
4. Move the horizontal bar to set which wire the
product will follow. The product can follow
Boundary wire left (Virtual boundary left),
Boundary wire right (Virtual boundary right)
or one of the
Virtual guides.
5. Move the horizontal bar to set the distance
the product must follow the
Virtual guide or
Virtual boundary. The product then leaves
the
Virtual guide or the Virtual boundary and
starts to cut the lawn. Refer to
the distance from the charging station on
page 35.
6. Move the horizontal bar to set how often the
product goes to each area. At all other
times, the products starts to cut near the
charging station. The percentage is equal to
the percentage of the area in relation to the
complete work area.
a) Measure the area.
b) Divide the area with the complete work
area.
c) Convert the result to %.
d) Move the horizontal bar to set the
distance from the charging station.
7. Select
Save.
To measure the distance from the charging
station
1. Put the product in the charging station.
2. Select
Settings > Installation > Lawn
coverage in the app.
3. Move the horizontal bar to set the distance
to the charging station to maximum.
1460 - 002 - 06.04.2020
Installation - 35
