max 1 cm / 0.4”
•
To install the
Virtual boundary around an
outer corner. Drive past the obstacle until
the product goes by the obstacle, add a set
point and then turn around the corner.
3.5.2.1 To install the Virtual boundary in a slope
The product can operate in 45% slopes. Slopes
that are too steep must be excluded from the
work area or isolated as
Stay-out zones. The
gradient (%) is calculated as height per m.
Example: 10 cm / 100 cm = 10%.
10 cm/4"
100 cm/40"
10%
•
For slopes steeper than 45% inside the work
area, isolate the slope with
Stay-out zone.
•
For slopes steeper than 15% along the outer
edge of the lawn. For installation of the
Virtual boundary, operate the product with
the rear wheel 5 cm / 2 in. (A) from the edge.
A
>10%
0-25%
•
For slopes adjacent to a public road, put a
fence or a protective wall along the outer
edge of the slope.
3.5.2.2 Passages
A passage is a section that has
Virtual boundary
on each side and that connects 2 parts of the
work area. The passage must be a minimum of
1.5 m / 5 ft. between the
Virtual boundary.
Note: If a passage is less than 2 m / 6.5 ft. wide,
install a
Virtual guide through the passage.
The product always runs to the left of the
Virtual
guide as seen facing the charging station. Make
sure that the
Virtual guide has as much free area
as possible to the left of the
Virtual guide (A).
1460 - 002 - 06.04.2020
Installation - 21
