Husqvarna AUTOMOWER 550 EPOS, Руководство оператора

Страница: 15 / 48

1. Install the reference station. Refer to the
Operator's manual for the reference station.
2. Install the charging station. Refer to
To install the
charging station on page 15 .
3. Install the Automower ® Connect app on your
mobile device. Refer to
To install the Automower ®
Connect app on page 16
.
4. Do a pairing operation of the product and the
Automower ® Connect app. Do the basic settings in
the start up sequence in the Automower
®
Connect
app. Refer to
To install the Automower
®
Connect
app on page 16 .
5. Make a map with work areas, stay-out zones,
transport paths and maintenance points. Refer to
To install objects on the map on page 17 .
6. Use Automower
®
Connect app to do settings for
the product. Refer to Settings on page 20 .
3.8.2 Installation tools
• Hex key, 8 mm. Included in the carton.
3.8.3 Installation of the charging station
Read and understand the instructions about the
charging station. Refer to
To examine where to put the
charging station on page 12 .
WARNING:
Obey national regulations
about electrical safety.
WARNING:
The product is only to be
used with the power supply unit supplied by
Husqvarna.
WARNING:
Do not put the power
supply at a position where there is a risk that
it can become wet. Do not put the power
supply on the ground.
WARNING:
Do not encapsulate the
power supply. Condensed water can harm
the power supply and increase the risk of
electrical shock.
WARNING:
Risk of Electric Shock.
Install only to an residual-current device
(RCD) with a tripping current of maximum 30
mA when connecting the power supply to
the wall socket. Applicable to USA/Canada.
If power supply is installed outdoors: Risk of
Electric Shock. Install only to a covered
Class A GFCI receptacle (RCD) that has an
enclosure that is weatherproof with the
attachment plug cap inserted or removed.
CAUTION:
Do not make new holes in
the charging station plate.
CAUTION:
Do not put your feet on the
baseplate of the charging station.
WARNING:
The power supply cable
and extension cable must be outside the
work area to avoid damage to the cables.
WARNING:
Make sure that the plugs of
the low-voltage cable and the power supply
unit are clean and dry before you connect
them.
When connecting the power supply, only use a power
outlet that is connected to an residual current device
(RCD).
3.8.3.1 To install the charging station
1. Put the charging station in the selected area.
2. Attach the charging station to the ground with the
supplied screws.
3. Connect the low-voltage cable to the charging
station.
4. Put the power supply at a minimum height of 30
cm / 12 in. Refer to
To examine where to put the
power supply on page 13 .
min 30 cm / 12”
5. Connect the power supply cable to a 100-240V
power outlet.
6. Put the low-voltage cable in the ground outside the
work area. Use stakes or bury the cable.
7. Put the product in the charging station to charge
the product.
3.8.3.2 To do a visual check of the charging station
1.
Make sure that the indicator LED lamp on the
charging station has a green light.
1576 - 004 - 16.11.2021 Installation - 15