Husqvarna 966412801, Руководство оператора и каталог запасных частей

Страница: 10 / 18

10
TIPS FOR IMPROVED BAGGING
Follow the mower operation instructions in you mower
operator’s manual.
When operating your grass catcher on a lawn where
grass and leaf bagging equipment has not been
used, you are picking up thatch and debris that has
accumulated for long periods of time. The amount
collected and the total time of operation may be
greater than you will experience with regular use of
your grass catcher.
Always run throttle at full speed when bagging. •
Select a speed low enough to give good mower •
cutting performance, good quality cut and good
bagging performance.
NOTE: It may be necessary to overlap width of
cut to suit your conditions.
If grass is extremely tall, it should be mowed twice. •
The first time relatively high, the second time to
desired height.
Use left hand side of mower for trimming.
•
Plastic trash bags (3.0 mil, 30 gallon) can be •
inserted inside grass catcher containers for ease
of debris disposal. To remove the plastic trash
bags when full:
a. Disengage blades, shift into neutral, engage
the parking brake and stop the engine.
b. Unlatch and raise cover.
c. Remove one container at a time by grasping
container handles and pulling toward the rear,
off of the tube rails.
d. With the container resting on the ground,
close and secure the top of the plastic lawn
bag.
e. Tip the container on its side and slide the
filled bag from the container.
f. Install a new plastic lawn bag with the edges
of the bag draped over upper lip of the
Container (for replacement bags refer to
REPLACEMENT PARTS).
g. Repeat for other container.
h. Reinstall containers making sure right
container overlaps left container at center
supports.
i. Close cover and secure latches over center
support tubes.
Avoid cutting wet grass or in the morning while the •
dew is still heavy. Grass clippings collected under
these conditions tend to be sticky and adhere to
the walls of the flow path causing clogging.
If the grass catcher fails to pick up cut grass •
or leaves, it is an indication that clogging has
occurred in the system or that the grass catcher
containers are full.
a. Disengage blades, place motion control levers
in neutral position.
- Unlatch and raise cover.
- Slide out containers and dispose of clippings.
- Replace containers, close cover, and latch.
b. Unlatch chutes and check for clogging.
- Remove all debris in chute.
- Reassemble and latch chutes.
OPERATION
GENERAL RECOMMENDATIONS
Always observe safety rules when performing any
maintenance.
Before each use check for loose fasteners. •
Clean unit thoroughly after each use. •
BLADE CARE
For best results mower blades must be kept sharp. •
Replace bent or damaged blades.
See BLADE CARE instructions in your mower
•
operator’s manual.
CAUTION
BEFORE PERFORMING
MAINTENANCE, SERVICE OR
ADJUSTMENTS:
• Set parking brake.
• Place motion control levers in
“NEUTRAL” position.
• Place clutch control in
“DISENGAGED” position.
• Turn ignition key to “OFF” position.
• Make sure blades and all moving
parts have completely stopped.
• Disconnect spark plug wire(s) from
spark plug(s) and place wire where
it cannot come in contact with plug.