A
3.9 Settings in Automower
®
Connect
The product has factory settings but the settings can be
adapted to each work area.
3.9.1 Schedule
In
Schedule
you can change the schedule settings for
the product. The
Schedule
is set individually for each
work area connected to the charging station.
Secondary
areas
cannot be scheduled.
The schedule function controls which hours the product
should operate and not operate. When the product is not
operating it is parked in the charging station. The
operating hours and days can be seen in an overview in
the Automower
®
Connect app.
The default schedule setting allows the product to
operate around the clock 7 days a week. This is
normally a suitable setting for a work area
corresponding to the maximum capacity. If the work
area is less than the maximum capacity the schedule
should be used to minimize wear on the grass and to the
product.
To calculate the schedule setting, refer to
the schedule setting on page 20
.
3.9.1.1 To calculate the schedule setting
1.
Calculate the dimension of your lawn in m
2
/ ft
2
.
2.
Divide the m
2
/ ft
2
of the lawn with the approximate
operation capacity. Refer to table below.
3.
The result is equal to the number of hours that the
product must operate each day.
Note:
The operation capacity is approximate and is
calculated for flat and open work area. If the work area
has a lot of slopes or obstacles, you need to increase
the
Schedule
settings.
Model
Approximate operation capaci-
ty, m
2
/h / ft
2
/h
Automower
®
550H
EPOS
208 / 2240
Example: A lawn of 3000 m
2
/ 32000 ft
2
, cut with an
Automower
®
550H EPOS.
3000 m
2
/ 208 ≈ 14.5 h.
32000 ft
2
/ 2240 ≈ 14.5 h.
Days / week
h / day
Schedule settings
7
14.5
7:00 - 21:30 / 7:00 am -
9:30 pm
3.9.2 Cutting height
The cutting height is set individually for each work area.
The cutting height can be set to 50-90 mm / 2.0-3.6 in.
3.9.3 Operation
In the Operation's menu it is possible to change the
settings of the
Weather timer, ECO mode
and
Spiral
cutting
.
3.9.3.1 Spiral cutting
If the product enters an area where it senses the grass
is longer than average, it can change the movement
pattern to
Spiral cutting
. This means that the product
mows in a spiral pattern to faster cut the area with
longer grass. It is possible to set the intensity of the
Spiral cutting
.
Very low / Low
intensity means that
Spiral
cutting
begins less often.
High / Very high
intensity
means that
Spiral cutting
begins more often.
Note:
Spiral Cutting
does not start in slopes steeper
than 15%.
20 - Installation
1619 - 002 - 19.01.2021
