Husqvarna 540i XP, Руководство оператора

Страница: 19 / 120

bar does not touch the tree and causes a
kickback.
To use the cutting technique
WARNING: Use full power when you cut and
decrease the speed to idle speed after each
cut.
CAUTION: Do not let the motor operate for
too long without load. This can cause
damage to the motor.
1. Put the trunk on a saw horse or runners.
WARNING: Do not cut trunks in a pile.
That increases the risk of kickback and
can cause serious injury or death.
2. Remove the cut pieces from the work area.
WARNING: Cut pieces in the work area
increase the risk of kickback and that
you cannot keep your balance.
To use the spiked bumper
1. Push the spiked bumper into the trunk of the tree.
2. Apply full power and rotate the product. Keep the
spiked bumper against the trunk. This procedure
makes it easier to apply the force necessary to cut
through the trunk.
To cut a trunk on the ground
1. Cut through the trunk on the pull stroke. Keep full
power but be prepared for sudden accidents.
WARNING: Make sure that the saw
chain does not touch the ground when
you complete the kerf.
2. Cut approximately ⅔ through the trunk and then
stop. Turn the trunk and cut from the opposite side.
To cut a trunk that has support on one end
WARNING: Make sure that the trunk does
not break during cutting. Obey the
instructions below.
1. Cut on the push stroke approximately ⅓ through the
trunk.
1065 - 002 - 13.05.2020 19