Husqvarna 540000073, Руководство по эксплуатации и запасным частям

Страница: 3 / 12

3
Congratulations! You have just purchased the
Husqvarna Towable Aerator - a precision-engi-
neered product designed to provide maximum
aeration performance and flexibility. Only a few
simple steps are required to fully assemble the
aerator. Please read these instructions before
beginning assembly. Assembly by two people
is recommended. If you have questions, please
contact your Husqvarna dealer or distributor.
TOOLS REQUIRED:
2 each 3/4” wrenches
1 each 9/16” deep-well socket
1 each 9/16” wrench
2 each 1/2” wrenches
OPTIONAL
WEIGHT CONTAIN-
ERS
TIP
WHEEL
TRANSPORT
WHEEL
JACK LIFT
ASSEMBLY
TOW BAR
PARTS INCLUDED:
Bolts: 1 each 5/16-18 x 3
4 each 3/8-16 x 1, Gr. 5
1 each 1/2-13 x 3 1/2, Gr. 5
1 each 3/8-16 x 1 3/4, Gr. 5
2 each 5/16-18 x 1, carriage
Nuts: 3 each 5/16-18, nyloc
1 each 1/2-13, nyloc
5 each 3/8-16, nyloc
Bushing: 5/8” x 9/16”
Washers: 2 each 1/2”, flat
6 each 3/8”, flat
2 each 5/16”, flat
Tow bar (1)
Jack (1)
Tie bar (2)
FIGURE 2
1. Check to see that all bolts, washers and
nuts are included in the plastic bag. Check
for any signs of damage that may have oc-
curred during shipment.
2. Tip aerator onto its back edge and install
jack lift assembly. Install 5/8” x 9/16” bush-
ing in hole “B” near end of the jack as-
sembly before inserting into frame mount.
Slide lift jack assembly between the two
frame mount brackets and align frame
mount hole “A” with lift assembly hole. See
Figure 2.
FIGURE 3
3. Install 1/2” x 3” bolt and washer through
frame mount and jack assembly. Add 1/2”
lock nut with washer and tighten. See Fig-
ure 3.
FIGURE 1
A
B
FRAME MOUNT
BRACKET
JACK LIFT
ASSEMBLY
TIE BARS
JACK LIFT
ASSEMBLY
ASSEMBLY