GENERAL SAFETY PRECAUTIONS
10 – English
Control panel
Make sure the machine is switched on or off when the
activate/deactivate button (1) is pressed and held (>1
sec.). The green LED (2) is lit or turned off.
Flashing warning indicator (3) and green LED (2) is lit
could indicate that:
•
it is not possible to apply full power and, at the same
time, activate the machine. Release the power trigger
and the machine is active.
•
the machine is blocked. Deactivate the machine.
Remove the battery from the machine. Remove the
twigs, branches or other materials that are jammed in
the blades.
•
the machine is overloaded due to heavy trimming.
Release the power trigger and the machine is active.
If the warning symbol (3) flashes, it indicates that the
machine is too hot and the machine deactivates. When
the machine is restored to normal temperature it is again
ready to run and you can activate the machine.
Solid red warning light (3) indicates service.
Power trigger lockout
The power trigger is designed to prevent accidental
operation. It is necessary to press both the power trigger
lockout and the power trigger. The order actuation power
trigger lockout and power trigger doesn’t matter. When
you release the handle, the power trigger and the power
trigger lockout both move back to their original positions.
This movement is operated by independent springs. This
arrangement means that the power trigger is
automatically locked at no operation state.
Turn on the machine.
Make sure the power trigger is locked when the power
trigger lock is in its original position.
Press the power trigger lockout and make sure it returns
to its original position when released.
Check that the power trigger and the power trigger lockout
move freely and that the return spring works properly.
The cutting unit must stop within 3 seconds.
See instructions under the heading Start. Start the
machine and apply full power. Release the power trigger
and check that the cutting attachment stops and remain at
a standstill.
!
WARNING! Never use a machine with
faulty safety equipment. The machine's
safety equipment must be checked and
maintained as described in this section.
If your machine fails any of these checks
contact your service agent to get it
repaired.
(2)
(1)
(3)
1
2