Husqvarna 525RJX, Руководство оператора

Страница: 12 / 86

ASSEMBLY
12 – English 1154813-49 Rev. No 1 2015-06-15
Fitting the loop handle
Clip the loop handle onto the shaft. Note that the loop
handle must be fitted between the arrows on the shaft.
• Slide the spacer into the slot in the loop handle. Fit the
nut and screw. Do not overtighten.
• Now adjust the trimmer to give a comfortable working
position. Tighten the bolt.
Fitting the J-handle
Attach the J-handle to the loop handle using the three
screws, as shown.
Now carry out fine adjustment to give yourself a
comfortable working position. Tighten the screws.
Fitting the suspension ring
Fit the suspension ring between the rear handle and the
loop handle. Position the hanging ring so that the machine
is balanced and comfortable to work with.
Use the harness and attach it to the suspension ring when
using grass blades.
Assembling the cutting
equipment
Fitting the trimmer guard and
trimmer head
• Fit the correct trimmer guard (A) for use with the
trimmer head. Hook the trimmer guard/combination
!
WARNING! Only grass blades/grass
cutters or trimmer heads/plastic blades
may be used when the J-handle is fitted.
Saw blades must never be used with the
J-handle.
!
WARNING!
When fitting the cutting attachment it is
extremely important that the raised
section on the drive disc/support flange
engages correctly in the centre hole of
the cutting attachment. If the cutting
attachment is fitted incorrectly it can
result in serious and/or fatal personal
injury.
!
WARNING! Never use a cutting
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is fitted this can
cause serious personal injury.