Husqvarna 525 LST, Руководство оператора

Страница: 17 / 36

• Make sure that the locknut can not be removed by
hand. If you can remove it by hand, it does not lock
the cutting attachment sufficiently and you must
replace it.
• Examine the blade guard for damages or cracks.
Replace the blade guard if it has been hit or if it has
cracks.
• Examine the trimmer head and cutting attachment
guard for damages or cracks. Replace the trimmer
head and cutting attachment guard if they have been
hit or if they have cracks.
WARNING: Do not use the product
without a guard or a guard that is
defective.
To prepare a cold engine for start
1. Push the air purge bulb again and again until fuel
starts to fill the bulb. It is not necessary to fill the air
purge bulb fully.
2. Move the choke control up into choke position.
WARNING: The cutting attachment
starts to rotate immediately when you
start the engine with the choke.
To start the product
WARNING: Read the warning instructions in
the safety chapter before you start the
product (refer to
Safety on page 4
).
1. Use protective gloves.
2. Hold the body of the product on the ground with your
left hand.
CAUTION: Do not use your feet!
3. Hold the starter rope handle.
4. Slowly pull out the starter rope with your right hand
until you feel some resistance (the starter pawl grip).
WARNING: Do not twist the starter rope
around your hand.
5. Pull the cord quickly and with power.
CAUTION: Do not pull the starter rope all
the way out and do not let go off the
starter rope handle when the starter rope
is fully extended. This can cause
damage to the product.
6. Pull the starter rope again and again until the engine
starts.
7. Reset the choke when the engine fires.
8. Operate the throttle gradually when the engine
starts.
9. Make sure the engine runs smoothly.
1363 - 001 - 25.10.2019 17