12
TROUBLESHOOTING
ELECTRIC MOTOR WILL NOT START
- Check that the power cord is properly plugged in correctly
and you have the proper voltage.
- Check that the circuit breaker on the electrical outlet is not
tripped.
- Check that the safety switch on the handle is in the “ON”
(green) position.
- Insure that you have rotated the handle clockwise to the
farthest position.
- Check that the blade shaft rotates freely and no concrete
build up in the blade block or motor.
- Check that the generator is ON and at full throttle.
- Check that the ground fault interrupter on the electrical outlet
is not tripped.
- Check that the extension cord is not faulty.
SAW IS SPALLING AND RAVELLING CUT
- Check to see if the diamond blade is worn out, glazed,
warped or damaged.
- Insure that the diamond blade moves freely through the skid
plate without contact.
- Check skid plate for excessive wear or gap around the
diamond blade.
- Check bottom of skid plate for metal burrs or irregularities.
- Insure skid plate is not twisted or bent.
- Do not twist or move the saw sideways while cutting.
- Check that the electric motor is running smoothly and
properly.
- Insure the diamond blade is properly mounted and secured
with clean flanges.
- Insure that the diamond blade is the corresct specification for
your area.
- Insure the slab is clean with no debris that could raise the
skid plate or saw while cutting.
- Use Husqvarna joint protectors at all cut intersections.
- Clean excess concrete debris from the blade guard
assembly, front diverter, skid plate and bottom plate.
- Do not stop the electric motor while the blade is in the cut.
MOTOR RUNS BUT BOGGS DOWN WHEN CUTTING
- Check that the extension cord is the proper wire gauge size
for the length of the used.
- Check that the generator is atleast 2800 watts and is at full
throttle.
- Check that the diamond blade is the correct specification for
the aggregate being cut.
- Check that the diamond blade is not worn out, glazed,
warped or damaged.
- Insure that the diamond is not being twisted in the cut.
- Check that the skid diamond blade is not contacting the skid
plate when cutting.
- Check the aggregate adjustment knob is set for the proper
aggregate for your area.
- Insure that the diamond blade is the corresct specification for
your area.
- Insure the diamond blade is properly mounted and secured
with clean flanges.
SAW PULLS TO ONE SIDE WHILE SAWING
- Check the front guide is properly aligned with the center of
the diamond blade.
- Check to see if diamond blade is worn out, glazed, warped or
damaged.
- Do not twist or move the saw sideways while cutting. Make
gradual changes in pressure on the handle bar to control the
saw in the cut.
- Insure that all wheels roll freely and smoothly.
- Do not force the saw. Allow the diamond blade to cut at its
own rate of speed.
- Check the skid plate for damage or burrs.