Husqvarna 355FRM, Руководство оператора

Страница: 56 / 88

ASSEMBLY
56 – English
• Fit the drive disc (B) on the output shaft.
• Turn the output shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
• Insert the locking pin (C) in the hole to lock the shaft.
• Place the blade (D) and support flange (F) on the output
shaft.
• Fit the nut (G). The nut must be tightened to a torque of
35-50 Nm (26-36 ft-lb). Use the spanner in the tool kit.
Hold the shaft of the spanner as close to the blade guard
as possible. To tighten the nut, turn the spanner in the
opposite direction to the direction of rotation (Caution!
left-hand thread).
When loosening and tightening the saw blade nut, there is a
risk of injury from the teeth of the saw blade. You should
therefore always ensure that your hand is shielded by the
blade guard when doing this. Always use a socket spanner
with a shaft that is long enough to allow this. The arrow in the
diagram shows the area where you should operate the
socket spanner when loosening or tightening the nut.
Fitting the shredder blade and the
shredder blade guard (555FRM)
• Fit the holder (K) and bracket (J) with 4 bolts (H) on
the gear housing.
• Then fasten the shredder blade guard (A) with 4 bolts
in the holder as shown.
F
G
D
B
C
J
K
H
A
x 4