Husqvarna 333R Mark II, Руководство оператора

Страница: 15 / 444

To clear
(Fig. 51)
To achieve the best results:
• Hold the trimmer so that the trimmer head is just
above the ground.
• Tilt the trimmer head at a slight angle.
• Let the end of the trimmer line strike the ground
around objects
To trim the grass
1. Hold the trimmer head immediately above the
ground at an angle. Do not push the trimmer line into
the grass. (Fig. 52)
2. Decrease the length of the trimmer line by 10-12
cm / 4-4.75 in.
3. Decrease the engine speed to decrease the risk of
damage to plants.
4. Use 80 % throttle when you cut grass near objects.
(Fig. 53)
To cut the grass
1. Make sure that the grass trimmer line is parallel to
the ground when you cut. (Fig. 54)
2. Do not push the trimmer head to the ground. The
ground and the product can be damaged.
3. Do not let the trimmer head touch the ground
continuously, it can cause damage to the trimmer
head.
4. Use full throttle when you move the product from
side to side to cut grass. Make sure that the grass
trimmer line is parallel to the ground. (Fig. 55)
To sweep the grass
The airflow from the rotating trimmer line can be used to
remove cut grass from an area.
1. Hold the trimmer head and its trimmer line parallel to
the ground and above the ground.
2. Apply full throttle.
3. Move the trimmer head from side to side and sweep
the grass.
WARNING: Clean the trimmer head cover
each time you assemble new trimmer line to
prevent unbalance and vibrations in the
handles. Also do a check of the other parts
of the trimmer head and clean it if
necessary.
To replace trimmer line
Refer to the last page of this operator's manual.
Maintenance
WARNING: Read and understand the safety
chapter before you clean, repair or do
maintenance on the product.
Maintenance schedule
Make sure that you obey the maintenance schedule.
The intervals are calculated from daily use of the
product. The intervals are different if you do not use the
product each day. Only do the maintenance work that is
found in this manual. Speak to an approved service
center about other maintenance work not found in this
manual.
Maintenance schedule Daily Weekly Monthly
Clean the external surfaces. √
Clean the air filter. Replace if necessary. √
Do a check of the harness. √
Do a check of the throttle trigger lock and the throttle function. √
Do a check of the handle and the handlebar. √
Do a check of the stop switch. √
Do a check of the guards. √
Do a check of the blade that it is sharp and not damaged. Install the
blade to the center position correctly.
√
Do a check of the trimmer head. √
Do a check of the cutting attachment and make sure that it does not
rotate at idle.
√
1542 - 002 - 17.07.2020 15