Husqvarna 220iL, Руководство оператора

Страница: 11 / 60

To assemble the loop handle
1. Attach the loop handle onto the shaft between the
arrows.
2. Move the spacer into the slot of the loop handle.
3. Install the screw and the knob. Do not tighten too
much.
4. Adjust the loop handle to an applicable position.
5. Tighten the knob.
To assemble the two-piece shaft
1. Turn the knob to loosen the shaft coupling.
2. Push in the lock button (A) and push the shaft into
the shaft coupling until the lock button sets in the
hole (B).
A
B
Note: If you cannot push the shaft fully into the shaft
coupling, turn shaft to make the internal drive shafts
connect.
3. Tighten the knob fully, before you operate the
product.
To disassemble the two-piece shaft
1. Turn the knob to loosen the shaft coupling.
2. Push and hold the lock button (A). Pull the shafts
apart.
A
B
1511 - 002 - 22.07.2020 11