Husqvarna 2014 TE 125 EU, Руководство пользователя

Страница: 85 / 128

15 ELECTRICAL SYSTEM
83
15.6 Installing the headlight mask with the headlight
B01787-11
Main work
–
Plug in connector
1
.
–
Check that the lighting is functioning properly.
–
Attach headlight holder
2
at catch
3
and position the headlight mask.
B01784-10
–
Position rubber bands
4
around the fork legs and close them.
The wiring harness and brake line
5
are routed in front of the headlight mask.
Finishing work
–
Check the headlight setting. ( p. 84)
15.7 Changing the headlight bulb
Note
Damage to reflector Reduced brightness.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. ( p. 82)
L00269-10
Main work
–
Turn protection cap
1
with the bulb socket beneath it all the way counterclockwise
and lift it off.
–
Pull bulb socket
2
of the parking light out of the reflector.
100463-10
–
Press headlight bulb
3
lightly into the bulb socket, turn it all the way counterclock-
wise, and pull it out.
–
Insert the new headlight bulb.
Headlight (S2/socket BA20d) ( p. 110)
–
Insert the protection cap with the bulb socket into the reflector and turn it all the way
clockwise.
–
Insert the bulb socket of the parking light into the reflector.
Finishing work
–
Install the headlight mask with the headlight. ( p. 83)
–
Check the headlight setting. ( p. 84)