Husqvarna 128PS, Руководство оператора

Страница: 15 / 80

Note:
Do not pull the throttle trigger while you
start the engine.
4. Pull the starter rope handle 3 times with force.
CAUTION:
Do not pull the
starter rope until it stops. Do not
let go of the starter rope when it is
fully extended. Release the starter
rope slowly. Failure to obey these
instructions can cause damage to the
engine.
5. Move the choke control to the half choke
position.
6. Pull the starter rope handle until the engine
starts.
7. Let the engine run for 10 seconds.
8. Move the choke control to the no choke position.
To start a warm engine
1. Slowly push the air purge bulb 10 times.
2. Move the choke lever to the HALF CHOKE
position.
3. Pull the starter rope handle quickly until the
engine runs.
4. Move the choke lever to the NO CHOKE
position.
To start the engine when the fuel is
too hot
If the product does not start, the fuel can be too hot.
Note:
Always use new fuel and decrease the
operation time during warm weather.
1. Put the product in a cool area away from open
sunlight.
2. Let the product cool down for 20 minutes at
minimum.
3. Press the air purge bulb again and again for
10-15 seconds.
4. Obey the procedure to start a cold engine. Refer
to To start a cold engine on page 14 .
To stop the product
• Push the stop switch to stop the engine.
Note:
The stop switch automatically goes back to
its initial position.
About the surface
WARNING:
Do not put parts of your
body in the grey marked area. If you
touch the grey marked area it can result
in burns to the skin. It can also cause
electrical shock if the spark plug cap has
been damaged. Do not use a product
with a damaged spark plug cap.
Maintenance
Introduction
Below you will find some general maintenance
instructions. If you need further information please
contact your service workshop.
Maintenance schedule
The following is a list of the maintenance steps that
must be performed on the product. Most of the items
are described later in this chapter.
Note:
The user must only carry out the
maintenance and service work described in this
operator's manual. More extensive work must be
carried out by an authorized service workshop.
1780 - 001 - 08.02.2022 15