Husqvarna 125 TC EU, Руководство пользователя

Страница: 44 / 109

11 SERVICE WORK ON THE CHASSIS
42
11.22 Removing the seat
B01819-10
–
Remove screws 1 in the recessed grips on the left and right.
–
Raise the rear of the seat, push the seat back, and lift it off.
11.23 Mounting the seat
L01630-01
–
Hook in the front of the seat at the collar bushing of the fuel tank, lower at the rear
and simultaneously push forward.
–
Make sure that the seat is correctly locked in.
–
Mount and tighten the screws for securing the seat.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
11.24 Removing the air filter box lid
L01918-10
–
Release catch
1
, pull off the air filter box lid sideways in areas
A
and
B
, and
remove toward the rear.
11.25 Installing the air filter box lid
L01918-10
–
Position the air filter box lid and catch 1 . Engage the air filter box lid in areas A
and B .
–
Engage catch
1
.
11.26 Removing the air filter
x
Note
Engine failure
Unfiltered intake air has a negative effect on the service life of the engine.
–
Never operate the vehicle without an air filter as dust and dirt will enter the engine and lead to increased wear.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Preparatory work
–
Remove the air filter box lid. ( p. 42)