Husqvarna Viking SAPPHIRE 9650Q, Руководство пользователя

Страница: 25 / 76

2:7 S
et
U
p
B
C
D
A
BOBBIN WINDING
BOBBIN WINDING THROUGH THE NEEDLE
Make sure that the presser foot and the needle are in the up
position.
1. Place an empty bobbin on the bobbin spindle on the
top of the machine. The bobbin only fits on one way,
with the logo facing up. Use only original HUSQVARNA
VIKING
®
bobbins.
2. Thread the machine with the main spool pin in the
horizontal position.
Note: If the thread spool is too large to be in horizontal
position, wind the bobbin as described under “Winding Specialty
Threads” below.
3. Bring the thread up from the needle, under the presser
foot and up to the right through thread guide (A).
Note: Use a metal presser foot when bobbin winding from the
needle.
4. Guide the thread through the hole in the bobbin from
the inside to the outside.
5. Push the bobbin winder spindle to the right to wind.
A pop-up appears on the screen to inform you that
bobbin winding is active. To adjust winding speed,
use the slider in the pop-up. Start bobbin winding by
pressing the foot control or touch the start/stop.
When the bobbin is full, it will stop winding. Release
the foot control or touch the start/stop button to stop
the bobbin winder motor from running. Move the
bobbin winder spindle to the left and the pop-up will
close. Remove the bobbin and cut the thread using the
bobbin thread cutter.
Note: It is important that you cut the thread end close to the
bobbin.
Note: Moving the bobbin spindle to the left will engage the
sewing mechanism. Always stop winding by pushing the Start/
Stop button or releasing the foot control before moving the bobbin
spindle.
WINDING SPECIALTY THREADS
We do not recommend winding speciality threads such as
“invisible” or other stretchy threads, metallic or flat metallic
threads through the needle.
Always wind these threads at minimum speed.
1. Place an empty bobbin on the bobbin spindle at the
front of the machine. The bobbin only fits on one way,
with the logo facing up. Use only original HUSQVARNA
VIKING
®
bobbins.
2. Place the large spool cap and a felt pad under the
spool on the main spool pin set in the vertical position.
3. Bring the thread over the Pre-Tension Thread guide
(B) and down around the thread tension disc (C), then
through thread guide (D) as illustrated.
4. See Bobbin Winding Through the Needle, step 4-5.
Note: When using earlier version of HUSQVARNA VIKING
®
bobbins that do not have a hole, wind several turns of thread on the
bobbin to get started.