Husqvarna Viking Lena, Руководство пользователя

Страница: 18 / 32

16
Sewing
Sewing Buttons
1. Mark the fabric where the button is to be
located.
2. Turn the stitch selector to zigzag .
3. Lower the feed teeth . See page 12.
4. Snap off the presser foot.
5. Place the material under the presser foot
ankle.
6. Place the button on marking and lower
the presser bar so that the presser foot
ankle is between the holes of the button
(see picture).
7. Hold the thread ends to one side. Turn
the handwheel and check to be sure that
the needle goes into the holes of the
button.
8. Sew 5-6 stitches. Set the stitch width dial
to 0 and lock the threads with a few stit-
ches.
Use the clearance plate for this purpose. Use
the thin end when sewing buttons on light
fabrics, the thick end for heavier fabrics.
Push in the plate between the button and
the fabric. Lower the presser bar and sew
on the button. Pull the threads between
the button and the fabric. Wind the threads
a few times around the shank and tie the
ends.
Cutting Buttonholes
Cut buttonhole open with the seam ripper.
Place a straight pin across the end you are
cutting toward to avoid cutting too far!