H U S k Y W I N E R E F R I G E R A T O R
5
direction of the lower hinge. Secure the lower hinge (2) to the left
side of the lower frame with the two screws (6) Re-insert the bolt
pin (7). Set the door into position, making sure it is seated
comfortably onto the lower hinge (2).
• Holding the door closed, secure the upper hinge (5) into the top
frame with the two screws (1). Check the door is level and tighten
the screws firmly.
BEFORE USING FOR THE FIRST TIME
• For good circulation, the vent at the back of the unit must not be
blocked. keep 50mm of clear space between the back of the
appliance and the wall, and 100mm between the sides and the wall.
Your Husky Wine Refrigerator should be placed on flat and firm
surface for quieter operation.
• If the appliance is to be placed on carpet, support it with a wooden
board underneath. Be aware that placing the appliance on carpet may
mean that heat from the compressor may cause the carpet to fade.
• Do not expose the appliance to direct sunlight or a heat source such
as ovens, radiators, heaters, etc.
• Do not under any circumstances place heated beverages in your
Husky Wine Refrigerator.
• Do not open the door more often than necessary to lessen the
escape of cold air.
• For better air circulation, do not overfill the unit.
• Adjust the temperature regulator according to the amount of product
and the ambient temperature.
OPERATION
The first time you switch the unit on, set the temperature control to the
“MAX” position. After 20 minutes, adjust the temperature control to “3”. This
setting should be correct for general use. To turn the unit off, turn the
temperature control to “0”.
Note:
turning the temperature control to “0” stops the cooling cycle but does
not shut the power off from the unit. If the unit is unplugged, turned off, or
in case of power failure, you must wait five minutes before restarting the
unit. If you do not wait, the unit may not start.
WARNING
If temperature selector is set to too low a setting, drinks become frozen. In
extreme circumstances, glass bottles may even break. Always exercise
caution when setting temperature.
• Do not place heavy items (more than 20kg) on top of the chiller.
• Do not place any items on top of the chiller which may fall off when
the door is opened.
SPECIFICATIONS
• This appliance is designed as a cooler for wine, soft drinks and beer.
• It is intended strictly for domestic use.
• The refrigerating circuit is leak-proof.
REVERSING THE DOOR HINGE
The door can be opened from left to right and vice versa. Should you wish to
change the opening direction, please follow these instructions.
Note:
all parts removed should be kept safely. You will require these for the
reinstallation of the door.
• Remove the two screws (1) that hold the upper hinge (5)(right side)
to the frame.
• Lift the door off and place on a padded surface to prevent scratching.
• Remove the blanking plug (8) from the hole in the upper left corner
of the door and transfer it to the uncovered hole on the upper right
corner. Press firmly to secure it.
• Remove the two screws (6) that hold the lower hinge (2)
• Remove the adjustable front left foot and transfer it to the other side.
• Remove the bolt pin(7) from the lower hinge (2) and reverse the
4
H U S k Y W I N E R E F R I G E R A T O R
Fig 1
Position of components
prior to reversal of the door hinge.
Fig 2
Position of components
after reversal of the door hinge.
