4
Assembly
1
Preparing the tripod
□
Loosen the tripod screw (AA) and move the support legs (2)
away from the center tube (1) of the tripod (A).
□
Push down on the leg connector until the support legs (2)
are fully extended and fi rmly tighten the tripod screw (AA).
□
Adjust the height of the tripod (A) by loosening the red twist
collar (3) on the center tube (1) and raising the pole section.
□
Firmly tighten the twist collar (3) once you have adjusted
the tripod (A) to the desired height.
□
Tighten the tripod screw (AA) to secure the base of the
tripod into position.
A
1
AA
2
3
2
Attaching the lamps to the tripod
NOTE:
Lamp head and stand sold separately.
□
Position the center of the stand (2) over the center of the
tripod (A) and insert the post on the bottom of the stand (2)
into the top of the tripod (A).
□
Push the lever (3) on the tripod (A) to lock the stand (2) in
place.
□
To unlock the stand (2) from the tripod (A), pull the lever (3)
and lift the stand (2) using the central handle (1).
A
3
1
2
Care and Cleaning
WARNING:
Always make sure that the worklight is detached
and cooled down before attempting to clean it.
□
Clean the tripod regularly with a non-abrasive cleaner.
□
Store in a safe and dry place, out of the reach of children.