12
Fluorescent light
4
40
Radio, fan, depth finder
9
24
Camcorder, VCR, spotlight 15
14
Power tools, bilge pump
24
10
Car vacuum
50
4
NOTE:
ALL TIMES ARE APPROXIMATE AND VARY WITH DIFFERENT APPLIANCES.
USAGE IS BASED ON A FULLY CHARGED UNIT.
5. EMERGENCY AREA LIGHT
The Area Light is controlled by an ON/OFF pushbutton. Make sure the lamp is
turned OFF when the unit is being recharged or stored. The efficient lamp will
operate up to 200 hours on a full charge.
6. TIRE INFLATOR
IMPORTANT:
Read Instructions Carefully To Avoid Possible Injury Or Property Damage.
The built-in 12 Volt DC inflator is the ultimate inflator for all vehicles, trailer tires
and recreational inflatables. Three different sized nozzles are supplied. Each
nozzle clips on the end of the standard tire valve connector located at the free
end of the inflator hose. The inflator nozzles are stored inside the hose hatch. The
inflator hose with tire fitting is stored in a retaining channel between the jumper
cable channels on the rear of the unit. The ON/OFF Switch is located on the
front of the Main Unit. The inflator can operate long enough to fill up to 3
average sized tires before the battery must be recharged.
The inflator may be used by removing the air hose from the storage hatch and if
required, fitting the appropriate nozzle to the air hose. Refer to Figure 2B for
locations of the inflator hose and nozzle storage hatch. Return hose to the
storage compartment after use.
NNN
NO
O
O
OTTTTEEEE:
The Husky HSK 037 inflator has an “overheat” automatic shutdown feature.
Around 15 min. of continuous use, the unit shuts down automatically and restarts
approx. 10 min. after cooling down.
6.1 WARNINGS FOR INFLATOR USE
The inflator is capable of inflating up to 200 pounds per square inch (PSI)
pressure. To avoid overinflating, carefully follow instructions on articles to be
inflated. Never exceed recommended pressures. Bursting articles can cause
serious injury. Always check pressure with the pressure gauge. Never leave
the inflator unattended while in use. Allow unit to cool after 15 minutes of
continuous operation.
6.2 TIRE INFLATION FOR PRODUCTS WITH A VALVE STEM
1. Place connector (chuck) on valve stem.
2. Push connector toward valve stem and close thumb latch.
NOTE: Make sure connector is pushed onto valve stem as far as possible
before closing thumb latch.
3. Slide inflator switch to ON.
4. Check pressure with the pressure gauge.
HSK037 ENG MANUAL 090105 9/1/05 5:48 PM Page 12
