Husky 676 532, Инструкция по использованию и уходу

Страница: 7 / 33

7 HUSKYTOOLS .COM
Please contact 1-888-43-HUSKY for further assistance .
Operation (continued)
5
Tightening or loosening the bolt or fastener
WARNING: Once a bolt or fastener is seated, impacting for
longer than five (5) seconds will cause excessive wear and
possible damage to the impact mechanism . If it takes longer
to tighten or loosen your bolt or fastener, we recommend the
use of a larger sized impact wrench .
□
Fit the impact socket .
□ Hold the impact wrench with one hand .
□
Ensure that the operator is aware of the torque direction to tighten
(Forward) or loosen (Reverse) and has selected the suitable torque level .
□
Use the tool to tighten or loosen the bolt or fastener .
Maintenance
Ensure the air line is shut-off and drained of air before removing this tool for service or changing sockets .
This will prevent the tool from operating if the throttle is accidentally engaged .
LUBRICATION
□
An in-line filter-regulator-lubricator is recommended as it increases tool life and keeps the tool in
sustained operation .
□ Regularly check and fill the in-line lubricator with air tool oil . Avoid using excessive amounts of oil .
□
Adjust the in-line lubricator by placing a sheet of paper next to the tool’s exhaust ports and holding the
throttle open approximately 30 seconds . The lubricator is properly set when a light stain of oil collects on
the paper .
□
If it is necessary to store the tool for an extended period of time (overnight, weekend, etc .), generously
lubricate the tool through the air inlet . Run the tool for approximately 30 seconds to ensure the oil is
evenly distributed throughout the tool . Store the tool in a clean and dry environment .
□
Recommended lubricants: Air tool oil or any other high grade turbine oil containing moisture absorbent,
rust inhibitors, metal wetting agents, and an EP (extreme pressure) additive .