Husky 1006 769 716, Инструкция по использованию и уходу

Страница: 7 / 33

7 HUSKYTOOLS.COM
Please contact 1-888-43-HUSKY for further assistance.
Operation (continued)
5
Tightening or loosening the bolt or fastener
WARNING:
Once a bolt or fastener is seated, impacting for
longer than five (5) seconds will cause excessive wear and
possible damage to the impact mechanism. If it takes longer
to tighten or loosen your bolt or fastener, we recommend the
use of a larger sized impact wrench.
□
Fit the impact socket.
□
Hold the impact wrench with one hand.
□
Ensure that the operator is aware of the torque direction to tighten
(Forward) or loosen (Reverse) and has selected the suitable torque level.
□
Use the tool to tighten or loosen the bolt or fastener.
Maintenance
Ensure the air line is shut-off and drained of air before removing this tool for service or changing sockets. This will
prevent the tool from operating if the throttle is accidentally engaged.
LUBRICATION
□
An in-line filter-regulator-lubricator is recommended as it increases tool life and keeps the tool in sustained
operation.
□
Regularly check and fill the in-line lubricator with air tool oil. Avoid using excessive amounts of oil.
□
Adjust the in-line lubricator by placing a sheet of paper next to the tool’s exhaust ports and holding the throttle open
approximately 30 seconds. The lubricator is properly set when a light stain of oil collects on the paper.
□
If it is necessary to store the tool for an extended period of time (overnight, weekend, etc.), generously lubricate
the tool through the air inlet. Run the tool for approximately 30 seconds to ensure the oil is evenly distributed
throughout the tool. Store the tool in a clean and dry environment.
□
Recommended lubricants: Air tool oil or any other high grade turbine oil containing moisture absorbent, rust
inhibitors, metal wetting agents, and an EP (extreme pressure) additive.
0
1
2
3
4
5