Operation
Positioning the pegboard
□
Pull the
slides
and
slide
carrier
out until
fully
extended
.
□
Hold
the
slide
on
the
cabinet
while
aligning
it
with
the
slide
on
the
drawer
.
□
□
Slowly
push
the
drawer
until
it
is
fully
closed
to
engage
the
slide
.
□
Open
the
drawer
and
close
it
to
verify
proper
operation
.
Slightly insert one side and repeat for the other side.
HUSKYTOOLS
.
COM
Please
contact
1-888-43-HUSKY
for
further
assistance
.
Locking
and
unlocking
the
unit
IMPORTANT
:
The
drawers
must
be
fully
closed
before
locking / unlocking
the
unit
.
8
1
3
□
To lock the unit, insert
the
key (K)
into the lock (O) and
turn
□
To unlock the unit, insert
the
key (K)
into the lock (O) and
it one quarter turn counterclockwise. Then remove the key.
turn
it
one quarter turn clockwise. Then remove the key.
Removing/installing
the
drawers
□
Fully
extend
and
empty
the
drawer
.
2
□
On the slide, lift up the plastic release lever on one slide
and push down the plastic release lever on the other slide.
Gently pull the drawer out so the slides can ride over
the stops.
K
Positioning the pegboard shelf
4
□
The pegboard shelf (R) can be installed using the pre-drilled
holes on either left side, center, or right side of the pegboard.
Removing the drawers -
Installing the drawers -
□
The pegboard is shipped and secured in its stored location.
□
To raise the pegboard to a usable height, remove the locking
thumb screws (T) at the top of the pegboard slides.
□
The pegboard can be raised to either mid or full height
position by pulling straight up. When in mid or full height
position, two pairs of ball detents will temporarily hold the
□
The locking thumb screw (T) holes and the tapped holes
located in the frame of the pegboard will align.
Reinstall the locking thumb screws (T) to secure the
□
pegboard in place.
pegboard.
T
R
