9134_Insert X 2.doc
02/19/03
CARPET LINER INSTALLATION INSTRUCTIONS
Your new 3D® Carpet Liners are designed to be held firmly in place with a Velcro® anchoring system. You
will find that each of your front liners come with two Velcro® “hook” patches applied to the underneath surface
of the liners. In the hardware bag included in the shipping container you will find 4 anchor screws with the
“loop” portion of the Velcro® applied. The anchor screws will need to be installed in your factory carpet
directly beneath the Velcro® hook patches to hold the liners in place. The anchor screws will not damage your
carpet and can easily be removed if necessary.
To align the anchors with the patches on the liner, first place your liner in the vehicle, adjusting it to the
proper fit. Then, pull up a corner of your liner as shown in the photo below and attach the anchor screw to the
Velcro® pad on the liner. Lower the raised edge and note the position where the anchor screw touches the
vehicle carpet. There are many ways to mark this location; here are a couple of suggestions:
•Apply a 1” strip of masking tape directly to the carpet underneath the anchor screw. When the anchor screw
is lowered, it will pierce the tape and mark the location.
•Insert a straight pin (needle) next to the point where the anchor screw contacts the carpet to mark the screw
location.
Removal of the factory carpet hook is recommended. The carpet hook can be removed using a
screwdriver to release them. Use a flat wide blade screwdriver, sliding it under the front edge of the
clip. Carefully apply pressure and twist to release the clip (pushing from the firewall towards the seat).
With screw secured in carpet, align Velcro®
halves to secure liner in place.
Anchor screw will pierce masking
tape, marking screw location.
Anchor screw shown attached to
Velcro® Dot on back of liner.
Velcro® Dot on back of liner.
