Huskie Tools SL-BND, Руководство по эксплуатации

Страница: 8 / 16

www.huskietools.com Page 8 800-860-6170
OPERATING INSTRUCTIONS
COMPRESSION
MAINTENANCE AND INSPECTION
1. Daily maintenance is required to ensure that the tool is kept in good working condition.
2. Check pressure of tool with factory approved pressure gage.
3. Do not store the tool in a humid environment.
4. Wipe away any excess oil with a soapy cloth.
5. Provided that maintenance of the tool is carried out regularly, the tool should provide
many years of service.
6. Should you experience any difficulty with the operation and maintenance of this tool,
contact Huskie’s technical support department at 1-800-860-6170.
1. Retract the ram by pressing the release button.
2. (a) Select an appropriate size of die for the connector. Insert the dies into the jaw by
pressing the push pins. (HT58 - “W” Dies) When the push pins are released, they will re
turn to their original position and hold the die in place.
(b) Insert dies (HT-Series “O” Dies) into jaw and twist set screw.
3. Place the connector between the dies.
4. The trigger and advance the ram so that the connector is held between the dies and
insert conductor into the terminal.
5. Press the trigger until the compression is completed. A clicking sound will be heard
while crimping and will stop once the
crimp is completed. A green LED on the side of the tool will be visible when a crimp is
complete.
6. Press the release button to retract the ram. The ram continues to retract while the re
lease button is pressed. The ram stops when it reaches the lower end.