Huskie Tools REC-6630, Инструкции по эксплуатации

Страница: 8 / 16

www.spartacogroup.com 800-860-6170
8
OPERATING INSTRUCTIONS
COMPRESSION
MAINTENANCE AND INSPECTION
1. Daily maintenance is required to ensure that the tool is kept in good
working condition.
2. Check pressure of tool with factory approved pressure gage.
3. Do not store the tool in a humid environment.
4. Wipe away any excess oil with a soapy cloth.
5. Provided that maintenance of the tool is carried out regularly, the tool should provide
many years of service.
6. Should you experience any difficulty with the operation and maintenance of this tool,
contact Huskie’s technical support department at 1-800-860-6170.
1. Check your connector manufacturers recommendations on using a dieless compression
tool with the connector and cable being used. Not all connectors are suitable for dieless
tool applications.
2. Retract the indenting nibs by pressing the release button.
3. Position the connector, and center it between the indenting nibs. Activate the trigger and
advance the nibs so the connector is held in place. Check connector for correct positioning.
4. Insert the cable into the connector and activate the trigger until the compression is
completed. A series of clicks will be heard while the compression is being made, followed by
the tool running in a “free” mode. This indicates a completed cycle and a full compression.
5. Press release button to retract the indenting nibs. and remove the connector from
the tool.