HUSABERG FE 450 AUS, Руководство по ремонту

Страница: 151 / 285

30/ENGINE ASSEMBLY
149
300518-10
–
Check the valve clearance at all valves between the valve and rocker arm.
Guideline
Valve clearance
Exhaust at: 20 °C (68 °F) 0.12… 0.17 mm (0.0047…
0.0067 in)
Intake at: 20 °C (68 °F) 0.10… 0.15 mm (0.0039…
0.0059 in)
Feeler gauge (59029041100) ( p. 269)
» If the valve clearance does not meet specifications:
–
Adjust the valve clearance. ( p. 149)
300299-11
–
Mount and tighten screw

.
Guideline
Plug, crank shaft location with thick
copper disk M8 10 Nm (7.4 lbf ft)
20.36
Adjusting the valve clearance
–
Remove the timing chain tensioner. ( p. 101)
–
Remove the camshaft. ( p. 101)
300524-10
–
Raise rocker arm

on the outside.
–
Remove shims

and set down in the position in which they were installed.
–
Correct the shims according to the findings from checking the valve play.
–
Insert the fitting shims

.
–
Install the camshaft. ( p. 148)
–
Install the timing chain tensioner. ( p. 148)
–
Check the valve clearance. ( p. 148)
20.37
Installing the generator cover
300361-10
–
Mount centering pins

. Position the generator cover seal.
300297-12
–
Position the generator cover. Mount screws

and tighten once all of the generator
cover screws have been mounted.
Guideline
Screw, generator cover M6x30 10 Nm (7.4 lbf ft)
–
Mount screws

and tighten once all of the generator cover screws have been
mounted.
Guideline
Screw, generator cover M6x50 10 Nm (7.4 lbf ft)
–
Mount screw

with the seal ring and tighten all screws in a crisscross pattern.
Guideline
Screw, generator cover
(chain shaft through-hole) M6x30 10 Nm
(7.4 lbf ft) Loctite ® 243™