Hurricane 3-PT 42, Быстрый старт

Страница: 11 / 19

HURRICANE DITCHER CO., INC. 3-PT 42 DITCHER
17
Step 3 – Remove the inspection plate behind both gearboxes and carefully inspect bearings, sprockets,
chain, and idler for damage. If damage is found, repair as needed, reinstall inspection plate using quality
grade silicone sealant under the inspection plate and return to Step 1. If no damage is found, continue to
Step 4.
Step 4 – Release chain tension until impeller wheel and PTO turn freely (See Idler Adjustment below)
IDLER ADJUSTMENT
Remove the inspection plate. Visually inspect the UHMW plastic wear pad for wear or damage.
Replace if needed. The idler adjustment assembly has two (1) bolt and three (3) nuts (See illustration
below). The nuts hold the idler assembly against the chain and act as a jam nut to lock the assembly in
position.
Chain needs
MORE tension:
•
Loosen Jam Nut C
•
Loosen Nut B
•
Tighten Nut A to remove any slack and apply slight tension on chain
•
Tighten Jam Nut B & C to secure the assembly
Chain needs
LESS tension:
Loosen Nut A until desired tension is reached
Tighten Nut B
Tighten Jam Nut C to secure the assembly
Small Gearbox -- Remove the inspection plate on back of the gearbox. Visually inspect the UHMW
plastic wear pad for wear or damage. Replace if needed. The idler adjustment yoke has two (2) nuts
(See illustration below). Nut A holds the idler assembly against the chain and Nut B acts as a jam nut to
lock the assembly in position. Reinstall inspection plate using quality grade silicone sealant under the
inspection plate.
Chain needs MORE tension:
§ Loosen Jam Nut C
§ Loosen Nut B
§ Tighten Nut A to apply tension on
chain
§
Tighten Nut B
§ Tighten Jam Nut C to secure the
assembly
Chain needs LESS tension:
§ Loosen Nut A until desired tension
is reached
§ Tighten Nut B
§ Tighten Jam Nut C to secure the