HURNER 200-230-084, Руководство пользователя

Страница: 35 / 139

Version September 2022
EN
13
HÜRNER HCU 300 User’s Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
6.2 Entering or Changing the Job Number
The commission number input screen is shown by the unit
before welding or accessed by the user in the quick access
screen (Display 6). It can be entered using the alphanumer-
ic keypad (see Info in Sect. 5.2) or by reading it from a bar
code using the scanner. The maximum length is 32 charac-
ters. Confirm your input by pressing the START/SET key. The
job number will be saved to memory and will appear in the
printed welding report.
6.3 Entering or Changing Additional Data
The additional data input screen is shown by the unit be-
fore welding, first the screen that allows entering the first
additional data, then the one for the second additional da-
ta. This input can be entered either using the alphanumeric
keypad (see Info in Sect. 5.2) or by reading from a bar code
using the scanner.
For the first additional data input, the maximum length
is 20 characters. For the second data input, the maximum
length is 15 characters. Confirm your input by pressing
START/SET. The additional data will be saved to memory and
appear in the welding report. By pressing STOP/RESET, you
skip this screen without any input.
Info
You are free to define any additional data you see
fit. For instance, you can put into these fields infor-
mation on pipe length, ditch depth, or comments
that help with welded joint traceability.
6.4 Entering the Fitting Traceability Code
If this feature is enabled in the configuration menu, after
the fitting code was entered, another input “Fitting Code”
is required. This is the so-called “traceability code” or “sec-
ond fitting code” of the fitting.
This input is entered either from a bar code using the scan-
ner or manually using the alphanumeric keypad (see Info in
Sect. 5.2). Press the START/SET key to confirm your input. If
the code entered is not correct, a “Code Error” message ap-
pears; check the string of numbers and correct as needed. If
the code entered is correct, it is saved to system memory and
inserted into the welding reports to be printed. By pressing
the STOP/RESET key, you skip this input.
6.5 Entering the Installing Company
In the same manner as the fitting traceability code (see
Sect. 6.4), entering a maximum of 15 characters for the com-
pany that performs the installation or reading its name from
Display 7
Enter Job No.
********************
************
Display 8
Enter Add. Data 1
********************
Display 9
*** Fitting Code ***
********************
******