HuRay HI-DELTA 2342ACE, Инструкция по установке и обслуживанию

Страница: 17 / 66

HANDLING MANUAL SERVICE MANUAL
RAYPAK HI DELTA BOILERS/WATER HEATERS
WITH FAN ASSISTED PREMIX BURNERS
17
2. TO THE ATTENTION OF THE USER
2.1. THINGS TO ARRANGE BEFORE THE FIRST OPERATION OF THE APPLIANCE
The installation of the Hi-Deltas must be executed by a
qualified person only. The procedure must be permitted by
the local gas supplier prior to the installation. The applying
standards and local regulation must be respected. The
installer has to notify the local gas supplier of the finish of
the work. The gas supplier tests the pressure tightness of
new gas pipes then connects them to the existing gas
network. One of the authorized services must be called for
the first operation of the appliance. The service person will
check out the proficiency of the installation, connects
electricity, starts up and tunes the appliance.
!
First operation of the appliance is allowed to be
executed by an authorized service only. The
warranty period starts as of the date of the first
operation. The service will charge you for first
starting the appliance.
2.2. HOW TO OPERATE THE APPLIANCE
Before starting up the Hi-Delta:
- Make sure that the appliance and the whole hydraulic
system is filled up with the proper heating substance!
-
Check out and stop drippings on the hydraulic system!
- Purge out air from the hydraulic system! Air being
strapped in the system may impede circulation.
-
Purge out air from gas pipes!
- Check in the warranty leaflet if the first start up of the
appliance was carried out by an authorized service.
Check out that the appliance is adjusted to the same
gas type being supplied!
- Have you looked over the operation instructions in
this handling manual, which was supplied together
with the appliance? Have you read the ”
SAFETY
INSTRUCTIONS 1.2. ”? In case of any abnormity
please call that service, which did the first start up of
the appliance!
For turning on the appliance:
- Switch off every electric supply that leads to the
appliance! Watch out for several electric supply
sources might be! Take off the side panel of the
electric control box!
- First turn the auto high limit to its lowest temperature
setting! Push in the red button on the manual high
limit to check out if it is not in locked position
lockout! Turn the auto high limit to its desired
operating temperature setting than turn the manual
high limit to a temperature setting at least 5
0
C higher
to the auto high limit!
- Check out and the pump overrun time on the TD
ECONO time delay relay! The value can be adjusted
between 1-10 minutes.
- Switch on every electric supply leading to the
appliance and power it by switching on the two poles
rocker switch on the C rail! The “UNDER
POWER” light goes on. Watch out for 230 V AC
equipments operating in the control box from now!
- Turn the rocker switch located on the side of the
appliance to “ON” position!
- Pushing the reset button of the ignition controller(s)
located on the C rail can be released any ignition
failure that could rise earlier. (It is also indicated by
the “SAFETY” light.)
- Open the gas cock leading to the appliance!
- Wait five minutes allowing any eventual gas residue
escaping! Check for smell of gas especially around the
floor! Follow the procedures given at the
"SAFETY
INSTRUCTIONS 1.2." if you smell gas!
- Continue turning on the appliance if there is no smell
of gas!
- Achieve heat demand by the proper setting of
thermostats and stage controllers! The „HEAT
DEMAND” light goes on.