Adjusting Head position.
Use Hex (allen) key provided to
loosen indicated screws to
adjust rotation and head angle.
Once desired postioning is
achieved tighten screws to lock
in place
LED replacement
Unscrew the Lens Ring. Remove Lens , Gasket, Hexcell and Reflector.
Pay close attention to component order. The LED holder can now be
unscrewed and the LED replaced. Reverse action to seal making sure
components are replaced in correct order. Incorrect order can lead to
failure of LED and/ or leaking. Please insure no dirt or grit is present
around lens or gasket.
NOTE: THESE INSTRUCTIONS MUST NOT CONTRAVENE YOUR
LOCAL ELECTRICAL AUTHORITY REGULATIONS, WITH WHICH
ALL INSTRUCTIONS HERE IN MUST COMPLY.
PLEASE KEEP INSTRUCTIONS FOR FUTURE REFERENCE.
Lens Ring
Gasket
Lens
Hexcell and packer
Reflector
LED holder
Do not water blast/jet wash this fixture under any circumstance
