HunterDouglas Nantucket, Инструкция по установке и эксплуатации

Страница: 7 / 32

INSTALLATION
5
■
Decide whether the front or back set of installation bracket holes works best in your
application. Mark the location of the screw holes.
➤
The minimum depth required for mounting is 2" with a
battery wand and a back cover.
➤
Minimum depth is 1
1
/
4
"
with a satellite battery pack or
DC power supply and back cover.
➤
The depth required for fully recessed mounting will vary
depending on the type of headrail and vane size. Refer
to the chart below for depth requirements.
IMPORTANT:
The front edges of the installation brackets must be level and aligned.
WARNING:
Failure to properly align the brackets could result in the headrail
releasing from the brackets.
■
Drill the screw holes using a
3
/
32
" drill bit.
CAUTION:
Use drywall anchors when mounting into drywall.
■
Use a level to check that the mounting surface is level. If necessary, you can shim the
brackets using the top tabs that were removed from the brackets.
■
Attach the installation brackets using the screws provided.
IMPORTANT: Do not overtighten the screws. Check to ensure the
lever can be moved easily side to side. If not, loosen the screws in
one-eighth turn increments until the lever can be moved easily.
■
If using the optional back cover:
Install the cover into
the back cover brackets. If necessary, trim the back cover
to the desired width.
IMPORTANT:
If using a battery wand, do not install the
optional back cover until the wand is installed (see page 12).
Proceed to “STEP 2 — Install the Shading” on page 10.
Minimum
Depth
2" Battery Wand
1
1
/
4
" Battery Pack or
DC Power Supply
2"
Fully Recessed
Mounting Depths
Classic
Headrail
Quartette
®
4"
Headrail
Battery Wand & Back Cover 4
1
/
16
" 4
9
/
16
"
Satellite Battery Pack or DC Power
Supply & Back Cover
3
1
/
2
" 4"
Back
Cover