Hunter TRIBECA 28120, Руководство по установке

Страница: 3 / 6

1. Disconnect power to the ceiling fan by turning off the circuit breakers both to the
outlet box and to its associated wall switch location.
2. Find the empty lower switch housing that came with your Tribeca TM fan. If you are
not sure what this piece is, refer to your Tribeca TM fan manual.
Note: If your Tribeca
TM
fan is already installed, you will need to remove the fan
only switch housing before proceeding. Refer to your Tribeca
TM
fan manual.
3. On the light kit housing, find the three recessed trim bezel screws and remove
them. Remove the trim bezel. Do not discard these screws. You will reuse them.
Note: e illustrations in the manual assume you are installing the light kit with
the globe fitter. If you want to use the light kit without the globe, remove the
three globe fitter screws and the globe fitter. Retain the globe fitter and the screws
in case you want to use the globe fitter in the future.
4. read the wires from the light kit through the hole in the center of the switch
housing. Attach the lamp holder assembly to the switch housing. Use 2 #6-32 x
5/8 inch screws. Align the holes and tighten the screws.
5. Connect the black wire in the light to the black wire with white stripe in the fan.
Connect the white wire in the light to the white wire in the fan. Secure both wire
connections with the ceramic wire nuts provided.
6. Attach switch housing to fan using three side screws provided with the fan.
Step 3
Globe Fitter
Trim Bezel
Globe Fitter
Screw
Recessed Trim
Bezel Screw
Step 4
Switch
Housing
Steps 5–6