Hunter Roam, Руководство пользователя и инструкции по установке

Страница: 24 / 28

20
TRoublesHooTinG Guide .............................................................
PROBLEM CAUSES SOLUTIONS
Transmitter display is blank. Transmitter is off.
Batteries are dead.
Press and hold the MODE button for 5 seconds.
Can’t access all the desired
stations on the Transmitter. Maximum station number is set wrong. See “Changing the Maximum Station.”
Receiver doesn’t beep 4 times
after plugging it in. SmartPort
®
is not connected properly.
Controller has no power.
Recheck SmartPort
®
wiring.
Check controller power.
Receiver won’t respond to
Transmitter. Receiver and Transmitter address don’t match Relearn address at receiver.
Transmitter display stays on. Transmitter will turn off automatically. Wait approximately 5 minutes without pressing any
buttons. Transmitter will “fall asleep.”
“ERR” message in controller
display when controller is in the
run position. SmartPort
®
wiring leads have been extended and are
receiving radio interference.
Replace lengthened wire with shielded cable to
prohibit radio interference. Use Hunter ROAM-SCWH.
See “Extending Wiring on SmartPort
®
Harness.”
Receiver does not receive signal
from remote held at close range. Mismatch of addresses in transmitter and receiver. Reset address of receiver.
Remote has short range
(i.e. less
t han 30 m).
Check for interference causes. See “Maximizing Operating Range.”