Hunter Residential/Light Commercial Remote Control System, Руководство пользователя и инструкции по установке

Страница: 10 / 28

1
/
2
" Thread
To Controller
Pre-assembled Assembled
6
Figure 1
1. Install a ½" female threaded “Tee” in the field
wiring conduit approximately 12" from the
controller.
2. Feed the red, white, and blue wires of the
SmartPort through the base of the “Tee” and into
the controller wiring compartment as shown in
Figure 1.
insTallinG THe RoaM ReMoTe WiRinG HaRness ...............
NOTE: Any extension of the wires
provided with the standard wiring
harness may result in an error
message on the controller display
and possible malfunction of the
remote due to radio interference. In
some situations, lengthening of the
standard harness may work fine, in
others it may not work at all (it is
site specific). In either case, it is
recommended that installations where
the SmartPort
®
outlet will be located
more than 5 feet from the controller
that the installation be done using the
shielded cable wiring harness (ROAM-
SCWH) to minimize the possible
effects of electrical noise.
NOTE: While the SmartPort has a
protective cover to allow for outdoor
installation, the ROAM Receiver
should only be used on a temporary
basis, as the Receiver is not
designated for permanent outdoor
mounting.
3. Screw the SmartPort housing into the “Tee”
(or other fitting) as shown in Figure 1.
4. Route wiring harness into controller housing.
Attach the red wire to the first AC screw slot.
Attach the white wire to the other AC screw slot,
and attach the blue wire to the R (or REM on
some controllers) as shown in Figure 2.