5
1886
1886
Ceiling Bracket
Hanging Fan
Wiring
Motor Housing
Blades
Light
Pull Chains
Control
Installing the Blades:
x12
x12
Repeat x4
bag
bag
Blade Screw
Washer
Fan style may vary.
Note:
Fan style may vary.
Note:
IMPORTANT
NOTE: Follow the instructions on the blade. Installing
it incorrectly could result in your fan not functioning.
Remove instructional label after installation.
Put the blade washers, found in the hardware bag, onto the
blade screws, found in the
hardware bag. Then install the blade
screws to secure each blade to a blade iron.
Partially install two of the canopy screws into
screw holes on opposite corners of the ceiling
plate as shown. Choose the two screw holes that
are aligned with the hanging slots in the fan body.
2 of 4
Canopy Screw
Installing the Motor Housing
2 of 4
Canopy Screw
Install the remaining two
canopy screws by holding the
fan body cover to the ceiling
mounting plate. Tighten all
four screws securely.
Align the hanging slots on both
sides of the fan body with the two
partially installed canopy screws.
Slide the two slots on both sides of
the fan body between the head of
the screws and rotate the fan body
counter clockwise so the screws
hold the fan body firmly in place.
WARNING
FAN FALL HAZARD
Make sure to secure the canopy.
There are four holes on the motor. Lift the mounting plate and
align the grommet holes in the mounting plate with the holes
of the motor. It does not matter which hole you choose. Install
the mounting plate screws found in the hardware bag to
secure the mounting plate to the fan.
Installing the Mounting Plate
x4
Mounting
Plate Screw
bag
bag
bag
