![Hunter H426 Скачать руководство пользователя страница 32](http://html.mh-extra.com/html/hunter/h426/h426_owners-manual_2184683032.webp)
MAINTENANCE
PAGE 25
COMPASSES
A boat compass rarely exists in an envi-
ronment that is completely free from
magnetic materials or influences.
The compass on your boat should be
adjusted by a certified compass adjuster
and have a deviation table made for it.
If you must depend solely on your com-
pass for navigation, make a quick check
for any objects near the compass that
may cause additional, unmeasured de-
viation. Typical objects that may fall in
this category include: knives, small ra-
dios, flashlights or other tools.
STEERING
Refer to the manufacturer
’
s instruction
for maintaining pedestal steering sys-
tem. Routinely inspect steering system
components.
CONTROL HAZARD
–
Inspect and
maintain steering system regularly. An
improperly maintained system may fail,
causing sudden loss of steering control,
resulting in personal injury and property
damage.
ELECTRICAL SYSTEMS
The electrical system is a 12-volt, nega-
tive ground installation, plus a shore
power system of either 120v or 220v.
The owner should inspect batteries,
terminals and cables weekly for signs of
corrosion, cracks, and electrolyte leak-
age. Battery terminals are to be kept
clean and greased. Refer to separate
instructions on batteries, wiring diagram,
and electronics.
SHOCK/FIRE HAZARD
Replace breaker or fuse with the same
amperage device. Never alter over cur-
rent protection.
SHOCK/FIRE HAZARD
Disconnect electrical system from its
power source before performing main-
tenance. Never work on the electrical
system while it is energized.
Electrical appliances must be within
the rated amperage of the boats cir-
cuits.
Observe boat carefully while the elec-
trical components that can be left unat-
tended are the automatic bilge pump,
fire protection and alarm circuits.
Only a qualified marine electrical tech-
nician may service the boat
’
s electrical
system.
Turn off engine before inspecting or
servicing battery.
Disconnect battery cables before work-
ing on electrical system to prevent arc-
ing or damage to alternator.
Содержание H426
