5
1886
Check the outlet box:
Installing the Ceiling Bracket
Ceiling Bracket
Hanging Fan
Wiring
Motor Housing
Blades
Light
Remote
Troubleshooting
Hanging the Fan
1
STEP
2
STEP
While holding the wires out of the way, lift the
motor assembly and place the square hanger
into the opening in the ceiling bracket. Be sure
the ground wire attached to the hanger faces
out of the large opening in the ceiling bracket.
Once the motor is in the ceiling bracket,
use the two locking screws found in the
hardware bag to secure the motor
to the ceiling bracket.
x2
bag
Have dual switches?
Follow these steps:
We know wiring is hard. Let’s make it easier.
Follow these steps to get your fan wired quickly and safely. Follow the route below that best matches your wall switch
setup. If you are unfamiliar with wiring or uncomfortable doing it yourself, please contact a qualified electrician.
Have a single switch?
Follow these steps:
Hunter Pro Tip:
Have extra wiring?
Turn the wires upward and push them carefully back through
the hanger bracket into the outlet box. Make sure that the
wires are still attached to the wire nuts.
Hunter Pro Tip:
Here is how to connect the wires:
Push the bare metal ends of the wires together and slide a wire
nut over them. Then, twist the wire nut clockwise until tight.
Give it a gentle pull to make sure none of the wires are loose.
Wiring the Fan
x4
bag
x4
bag
Connect the white
(grounded) wire from
the ceiling to the white
wire from the fan.
Connect the three
grounding wires (green,
green/yellow stripe, or
bare copper) coming from
the ceiling and hanging
bracket.
Connect the black wire
(ungrounded) from the
ceiling to the black
wire from the fan.
Cap the blue wire from
the fan. It will not be used
for single switch wiring.
Black
Blue
White
Ungrounded
Grounded
Grounding
G
r
ee
n
/
Ye
l
lo
w
St
r
i
p
e
G
r
ee
n
/
Ye
l
lo
w
St
r
i
p
e
Connect the white
(grounded) wire from
the ceiling to the white
wire from the fan.
Connect the black wire
(ungrounded) from the
ceiling to the black
wire from the fan.
Black
Blue
White
Ungrounded
Grounded
Grounding
G
r
ee
n
/
Ye
l
lo
w
St
r
i
p
e
G
r
ee
n
/
Ye
l
lo
w
St
r
i
p
e
Connect the second
ungrounded (light)
wire from the
ceiling to the blue
wire from the fan.
Ungrounded (light)
Connect the three
grounding wires (green,
green/yellow stripe, or
bare copper) coming from
the ceiling and hanging
bracket.
Wire Nut
Wire Nut
Locking
Screw
NOTICE
To prevent damage to fan,
ALWAYS lift holding either the
fan housing or the downrod.
WARNING
All wiring must be in accordance with
national and local electrical codes ANSI/NFPA
70. If you are unfamiliar with wiring or in
doubt, consult a qualified electrician.
