5
41081-01 • 08/04/09 • Hunter Fan Company
2 • Installing the Hanger Bracket
2-1. Drill two pilot holes into the wood support structure through
the outermost holes in the outlet box, using the ceiling plate as a
guide. The pilot holes should be 9/64” in diameter.
2-2. Install one canopy screw into each side of the ceiling plate as
shown.
2-3. Place a flat washer on each of the two 3” wood screws.
2-4. Thread the lead wires from the outlet box down through the hole
in the middle of the ceiling plate.
2-5. Align the slotted holes in the ceiling plate with the pilot holes you
drilled in the wood support structure.
2-6. Pass the wood screws through the slotted holes in the hanger
bracket into the pilot holes you drilled.
Tighten the wood screws into the 9/64” pilot holes; do not use
lubricants on the screws. Do not over tighten.
Flat Washer
3” Wood Screw
Step 2-2
Step 2-1
Canopy Screw
